Bar Pin Eliminator Kit for Jeep Cherokee and Wrangler 4WD
- Fits 1984-2001 Jeep Cherokee 4WD and 1997-2006 Jeep Wrangler 4WD
- Replaces the factory front lower bar pin shock mount with a bolt-on unit
- Not compatible with shocks using a bonded bar pin or bushing
- Addresses rattling from the original bar pin mount
- Install time: 1-2 hours — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
Will NOT work on shocks equipped with a bonded barpin/bushing. Fitment on this page is based on the manufacturer’s application data.
About this part
Bar Pin Eliminator Kit, fitment-checked
Rough Country 1088 is a bar pin eliminator kit for 1984-2001 Jeep Cherokee 4WD and 1997-2006 Jeep Wrangler 4WD. It takes the place of the factory front lower bar pin shock mount with a bolt-on connection that is sturdier than stock and quiets the rattle the original mount can develop. It will not work with shocks that use a bonded bar pin or bushing.
This bar pin eliminator kit for the 1984-2001 Jeep Cherokee 4WD and 1997-2006 Jeep Wrangler 4WD swaps the front lower bar pin shock mount for a bolt-on setup, so check your shock ends first: shocks with a bonded bar pin or bushing are not compatible. Covered applications run from Cherokee Base and Laredo through Wrangler Sport, Sahara, Rubicon, and Unlimited trims listed in the fitment section. Rough Country lists 1-2 hours for installation, and a downloadable installation guide is available. Shipping weight is 1 lb.
Specifications
Specs
| Brand | Rough Country |
| Part number | 1088 |
| UPC / GTIN | 00843030100933 |
| Shipping weight | 1 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Shocks & Struts |
Why buy here
The fitment-first store
Keep looking
More Shocks & Struts
