Quick Disconnect Sway Bar Links for 1997–2006 Jeep Wrangler 4WD
- Fits 1997–2006 Jeep Wrangler 4WD, including SE, Sport, Sahara, X, Rubicon, and Unlimited models
- Only for Wranglers with 2.5 in of suspension lift — verify your setup first
- Bolt-on install with no fabrication; pull the pin to disconnect for added front articulation
- Disconnected links secure out of the way until you reconnect them
- Install time listed as 1-2 hours; downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
ONLY fits models with 2.5in of suspension lift. Fitment on this page is based on the manufacturer’s application data.
About this part
Quick Disconnect Sway Bar Links, fitment-checked
Rough Country 1129 is a set of quick disconnect sway bar links for the 1997–2006 Jeep Wrangler 4WD, covering SE, Sport, Sahara, X, Rubicon, Unlimited, Unlimited Rubicon, and 65th Anniversary Edition. These fit only Wranglers already running 2.5 in of suspension lift, so confirm your lift height before ordering.
These quick disconnect sway bar links suit the 1997–2006 Jeep Wrangler 4WD and are sized for rigs sitting on 2.5 in of suspension lift — stock-height and other lift heights are outside this application. The links bolt on with no fabrication, and pulling the pin at the trailhead frees the front sway bar so the axle can articulate further over uneven ground; the disconnected end stows out of the way and reconnects for the drive home. Rough Country lists roughly 1-2 hours of installation time, and a downloadable installation guide is available. Shipping weight: 5 lb.
Specifications
Specs
| Brand | Rough Country |
| Part number | 1129 |
| UPC / GTIN | 00843030101237 |
| Shipping weight | 5 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Sway Bars |
| Installation guide | Downloadable PDF |
Why buy here