Winch Mounting Plate for Jeep Cherokee & Grand Cherokee (1993-1998)
- Fits 1993-1998 Jeep Cherokee and Grand Cherokee 4WD — see the fitment table for covered trims
- Bolts to the factory front bumper and secures to the frame behind it
- Accepts most winches on the market
- Bumper trimming required; downloadable installation guide available
- Install time: 1-2 hours
The Trail Fortress check
Will it fit your truck?
✓ Fits
Bumper trimming is required. Fitment on this page is based on the manufacturer’s application data.
About this part
Winch Mounting Plate, fitment-checked
Rough Country 1049 is a winch mounting plate for 1993-1998 Jeep Cherokee and Grand Cherokee 4WD models. It bolts to the factory front bumper and ties into the frame behind it, and it accepts most winches on the market. Trimming the bumper is part of the job.
A winch mounting plate for the 1993-1998 Jeep Cherokee and Grand Cherokee 4WD, this plate anchors to the frame behind the factory front bumper so the bumper itself stays in place. Most winches on the market bolt up to it. Plan on trimming the bumper for clearance, since that is part of the install rather than an optional step. Rough Country puts the job at 1-2 hours, and a downloadable step-by-step installation guide is available. Check the fitment section for the trims covered, from Base and SE through Laredo, Limited, Orvis, and TSi.
Specifications
Specs
| Brand | Rough Country |
| Part number | 1049 |
| UPC / GTIN | 00843030100469 |
| Shipping weight | 53 lb |
| Country of origin | US |
| Category | Recovery & Winches › Jacks & Mounting |
| Installation guide | Downloadable PDF |
Why buy here