Fender Flares with 5.5-Inch Height for Ford F-150 (2021-2026)
- Fits 2021-2026 Ford F-150 including Tremor and STX, 4WD and RWD
- 2 inches of added width, 5.5-inch flare height
- Does not fit Raptor models or trucks with OEM power running boards
- Factory-point install, no drilling; downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
✕ Does not fit
- Models equipped with OEM power running boards
Due to variances in fender design, these flares will NOT fit Raptor models. California Residents: Prop65 Warning. Fitment on this page is based on the manufacturer’s application data.
About this part
Fender Flares with 5.5-Inch Height, fitment-checked
Fitment on this set reaches across the 2021-2026 F-150 lineup — STX, XL, XLT, Lariat, King Ranch, Platinum, Limited, Tremor, Police Responder, and SSV, in 4WD and RWD. The flares extend 2 inches with a 5.5-inch height and mount at factory points without drilling. Trucks with OEM power running boards and Raptor models are not covered by this application.
Trim breadth is the story here. The 2021-2026 F-150 application includes Tremor and STX alongside the XL, XLT, Lariat, King Ranch, Platinum, Limited, Police Responder, and SSV, in both drive configurations. Each flare stands 5.5 inches tall and pushes 2 inches outward for coverage over a wider wheel and tire setup. The install is a factory-location bolt-on with no drilling, and the flares are removable if you go back to the stock look. Tri-blend ABS resists impact and UV fade, and the surface is paintable. Raptor models and OEM power running boards are the two exclusions.
Specifications
Specs
| Brand | Rough Country |
| Part number | F-F320210A-RCGB |
| UPC / GTIN | 00840269949876 |
| Lift height | 5.5 in |
| Shipping weight | 32 lb |
| Warranty | 3 Year Limited Warranty |
| Country of origin | US |
| Category | Exterior Accessories › Fender Flares |
| Installation guide | Downloadable PDF |
Why buy here