Bar Pin Eliminator Kit for Jeep Wrangler 4WD/RWD (1997-2017)
- Fits 1997-2017 Jeep Wrangler in 4WD and RWD, including Unlimited and Anniversary Edition submodels
- Replaces the factory rear upper bar pin shock mount with a stronger bolt-on mount
- Addresses rattle coming from the factory bar pin mount
- Not compatible with shocks using a bonded bar pin or bushing
- Install time listed at 1-2 hours; downloadable installation guide available
Will it fit your truck?
✓ Fits
Will NOT work on shocks equipped with a bonded barpin/bushing. Fitment on this page is based on the manufacturer’s application data.
More for your truck
Bar Pin Eliminator Kit, fitment-checked
Rough Country 1089 is a bar pin eliminator kit for the 1997-2017 Jeep Wrangler in 4WD and RWD form. It swaps out the rear upper bar pin shock mount for a bolt-on setup that holds tighter than the factory arrangement and quiets the rattle that mount can produce. It will not work with shocks that use a bonded bar pin or bushing.
This bar pin eliminator kit for the 1997-2017 Jeep Wrangler 4WD and RWD replaces the rear upper bar pin shock mount, covering Sport, Sport S, Sahara, Rubicon, SE, X, the Unlimited variants, and the 65th, 70th, and 75th Anniversary editions listed in the fitment section. Mounting is bolt-on, with a listed install time of 1-2 hours, and a downloadable Rough Country installation guide is available. Before ordering, check the shocks already on the Jeep: shocks built with a bonded bar pin or bushing are not compatible with this kit. Shipping weight: 2.0 lb.
Specifications
| Brand | Rough Country |
| Part number | 1089 |
| UPC / GTIN | 00843030100940 |
| Shipping weight | 2 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Shocks & Struts |
Why buy here
More Shocks & Struts
9 Inch