Retractable Bed Step for Jeep Gladiator 4WD (2020-2026)
- Fits 2020-2026 Jeep Gladiator 4WD — see the full submodel list in the fitment section
- Passenger's-side mounting only; does not fit trucks with bedside rock sliders
- May interfere with aftermarket exhaust systems — verify your setup first
- No-drill bolt-on install; Rough Country lists 30 minutes, downloadable installation guide available
- 6-inch wide die-cast aluminum board with a 5-inch drop, rated to 330 pounds
The Trail Fortress check
Will it fit your truck?
✓ Fits
May not work with aftermarket exhaust systems. Installs on the passenger's side of the vehicle ONLY. Fitment on this page is based on the manufacturer’s application data.
About this part
Retractable Bed Step, fitment-checked
Rough Country PW050158 is a retractable bed step for the 2020-2026 Jeep Gladiator 4WD. The die-cast aluminum board is 6 inches wide, drops 5 inches for easier bed access, and deploys with a tap of your foot. It mounts on the passenger's side only, may conflict with aftermarket exhaust, and will not work on trucks running bedside rock sliders.
This retractable bed step fits the 2020-2026 Jeep Gladiator 4WD across the submodel list shown in the fitment section, from Sport and Willys through Rubicon and Mojave. It bolts on without drilling, and Rough Country lists the job at 30 minutes. The 6-inch aluminum board carries a textured tread surface and is rated to hold up to 330 pounds, dropping 5 inches below the bedside when kicked open. Confirm two things before ordering: the step goes on the passenger's side only, and trucks with bedside rock sliders are not supported. A downloadable installation guide is available.
Specifications
Specs
| Brand | Rough Country |
| Part number | PW050158 |
| UPC / GTIN | 00840269972874 |
| Shipping weight | 20 lb |
| Country of origin | CN |
| Category | Exterior Accessories › Running Boards |
| Installation guide | Downloadable PDF |
Why buy here