Fender Flare Delete for Ford Bronco 4-Door (2021-2026)
- Fits 4-door 2021-2026 Ford Bronco 4WD only
- Does not fit Everglades, Heritage Edition, Heritage Limited Edition, or Raptor
- Laser-cut 1/8-inch plate steel with a black powder coat finish
- Drilling required; nutsert tool 10583 recommended
- Install time listed at 2-3 hours; downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
✕ Does not fit
- Everglades Heritage Edition Heritage Limited Edition or Raptor models
ONLY fits 4-door models. Requires drilling for installation. For ease of installation a nutsert tool is recommended 10583. For tips on how to install a nutsert please watch this video here! Fitment on this page is based on the manufacturer’s application data.
About this part
Fender Flare Delete, fitment-checked
The 51061 flare delete swaps the factory fender flare on the 4-door 2021-2026 Ford Bronco for laser-cut 1/8-inch plate steel in a black powder coat, contoured to follow the body line. Drilling is required. It does not fit Everglades, Heritage Edition, Heritage Limited Edition, or Raptor models.
Only 4-door Broncos are covered here, and the exclusions run deeper than that: Everglades, Heritage Edition, Heritage Limited Edition, and Raptor are all out. The rest of the 2021-2026 Bronco 4WD range in the fitment section — Base, Big Bend, Black Diamond, Badlands, Outer Banks, Wildtrak, First Edition, Stroppe Edition — is supported. The laser-cut steel panel opens up travel and ground clearance where the factory flare sat, and it is shaped to follow the body line rather than leave a raw opening. Rough Country lists 2-3 hours, and drilling is required; a nutsert tool such as 10583 makes that step easier.
Specifications
Specs
| Brand | Rough Country |
| Part number | 51061 |
| UPC / GTIN | 00840269901119 |
| Shipping weight | 17 lb |
| Country of origin | US |
| Category | Exterior Accessories › Fender Flares |
| Installation guide | Downloadable PDF |
Why buy here