WF1 Fender Flares for Jeep Wrangler (2018-2025)
- Fits 2018-2025 Jeep Wrangler 4WD, Sport through Rubicon 392 and 4xe, standard and Unlimited
- 10-inch front flare width, 6-inch rear
- Clears up to 35-inch tires on non-Rubicon and 37-inch on Rubicon without a lift
- Adds 3/4 inch of front clearance on Rubicon, 2 inches on non-Rubicon
- No-drill install with minor trimming; factory blinkers retained; 2-3 hours listed
The Trail Fortress check
Will it fit your truck?
✓ Fits
Retains factory blinker. Fitment on this page is based on the manufacturer’s application data.
About this part
WF1 Fender Flares, fitment-checked
The WF1 set runs 10 inches wide at the front and 6 inches at the rear on the 2018-2025 Jeep Wrangler, and it clears up to 35-inch tires on non-Rubicon trucks or 37-inch on a Rubicon without adding a lift. Clearance over the factory flare improves by 3/4 inch on Rubicon fronts and 2 inches elsewhere. Installation is no-drill, though minor trimming is required, and the factory blinkers stay in place.
Fitment covers the full 2018-2025 Wrangler 4WD list — Sport, Sport S, Willys, Sahara, High Altitude, Rubicon, Rubicon X, Rubicon 392, the 4xe variants, and every Unlimited equivalent. The lightly textured TPO is UV-protected against fading and cracking, which matters on a vehicle that lives with the top off. Corrosion-resistant hardware is included and no drilling is needed, but plan on minor trimming to land the fit, and set aside the 2-3 hours Rough Country lists. The factory turn signals carry over rather than being replaced.
Specifications
Specs
| Brand | Rough Country |
| Part number | A-J01822 |
| UPC / GTIN | 00840269912436 |
| Shipping weight | 26 lb |
| Warranty | Limited Lifetime Warranty |
| Country of origin | US |
| Category | Exterior Accessories › Fender Flares |
| Installation guide | Downloadable PDF |
Why buy here