Quarter Panel Armor for 1997–2001 Jeep Cherokee XJ, Trimmed Flares
- Cut from 3/16-inch plate steel for the rear lower quarter
- Fits 1997–2001 Jeep Cherokee XJ in 4WD and RWD
- Profiled for trimmed fender flares rather than untouched factory flares
- Requires drilling and removal of the factory bumper caps; nutsert tool 10583 recommended
The Trail Fortress check
Will it fit your truck?
✓ Fits
Requires drilling MUST remove factory bumper caps prior to installation For ease of installation a nutsert tool is recommended 10583. For tips on how to install a nutsert please watch this video here! Fitment on this page is based on the manufacturer’s application data.
About this part
Quarter Panel Armor, fitment-checked
If your XJ's fender flares have already been trimmed, 10572 is the rear quarter panel that matches that profile. It is 3/16-inch plate steel, and it hides the raw edges that show once the factory bumper caps come off a 1997–2001 Jeep Cherokee. Drilling is part of the job.
Rear quarter panel armor for the 1997–2001 Jeep Cherokee XJ, cut for vehicles running trimmed fender flares rather than untouched factory pieces. Coverage spans 4WD and RWD Classic, Country, Limited, SE, and Sport models. Pull the factory bumper caps before you start; the panels are what goes over the exposed metal afterward. Drilling is required, and a nutsert tool speeds up the fastener work. Rough Country puts the job at 1-2 hours and publishes a downloadable installation guide. Shipping weight: 11.0 lb.
Specifications
Specs
| Brand | Rough Country |
| Part number | 10572 |
| UPC / GTIN | 00843030149772 |
| Shipping weight | 11 lb |
| Country of origin | US |
| Category | Bumpers & Armor › Body Armor |
| Installation guide | Downloadable PDF |
Why buy here