2.5 Inch Lift Kit with N3 Shocks for 1978-1979 Ford Bronco 4WD

About this kit

2.5 Inch Lift Kit with N3 Shocks, fitment-checked

Rough Country 40530 is a 2.5 inch lift kit for the 1978-1979 Ford Bronco 4WD, built around lifted front coil springs, 4-degree C-bushings, a track bar drop bracket, rear lift blocks with U-bolts, and two N3 shock pairs. It raises ground clearance and takes out factory nose-down rake. Estimated install time is 4-6 hours.

This 2.5 inch lift kit for the 1978-1979 Ford Bronco 4WD covers Custom, Northland, and Ranger XLT applications. The front side uses lifted coil springs, 4-degree C-bushings, and a track bar drop bracket to keep axle position sane at the new ride height; the rear runs lift blocks with U-bolts and hardware. Two N3 shock pairs and two installation kits round out the box. Trucks that left the factory with quad shocks — two front shocks per side — run a single aftermarket shock per side instead. Plan on 4-6 hours of driveway time, and check the tire and wheel chart before choosing a setup.