N3 Steering Stabilizer for Ford Bronco II 4WD/RWD (1984-1990)
- Fits 1984-1990 Ford Bronco II in 4WD and RWD, including Base, XL, XLS, XLT, XLT Plus, and Eddie Bauer
- Not compatible with vehicles running a front sway bar
- Bolt-on mounting — no cutting or drilling; listed install time is 1 hours
- N3 stabilizer damps bump steer and eases load on tie rods and ball joints
- Downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
Vehicles equipped with a front sway bar can NOT use Rough Country's single steering stabilizer. Fitment on this page is based on the manufacturer’s application data.
About this part
N3 Steering Stabilizer, fitment-checked
Rough Country 8733130 is an N3 single steering stabilizer for the 1984-1990 Ford Bronco II in both 4WD and RWD form. It bolts on with no cutting or drilling to steady steering feel and cut down on feedback through the wheel. Trucks running a front sway bar cannot use this single-stabilizer setup.
This N3 steering stabilizer for the 1984-1990 Ford Bronco II 4WD and RWD covers Base, XL, XL Sport, XLS, XLT, XLT Plus, and Eddie Bauer submodels listed in the fitment section. The single-stabilizer design will not work on a Bronco II fitted with a front sway bar, so confirm what is under the front end before ordering. Mounting is bolt-on, with no cutting or drilling called out, and Rough Country lists roughly 1 hour of install time. A downloadable installation guide is available to walk through the hardware layout before you start.
Specifications
Specs
| Brand | Rough Country |
| Part number | 8733130 |
| UPC / GTIN | 00843030146962 |
| Shock package | N3 series |
| Shipping weight | 10 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Steering Stabilizers |
| Installation guide | Downloadable PDF |
Why buy here