Rear Coil Spring Correction Plates for Jeep Wrangler (2007-2017)
- Fits 2007-2017 Jeep Wrangler in 4WD and RWD, including Unlimited submodels
- Corrects rear coil angle by 10 degrees so the springs seat and load properly
- Recommended for use alongside 3.5in to 6in suspension lift kits
- Bolt-on install, estimated at 2-3 hours — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
Recommended for use with 3.5in - 6in suspension lift kits. Fitment on this page is based on the manufacturer’s application data.
About this part
Rear Coil Spring Correction Plates, fitment-checked
Rough Country 1113 is a pair of rear coil spring correction plates for the 2007-2017 Jeep Wrangler, in both 4WD and RWD. They reset the rear coil angle by 10 degrees so the springs seat and work the way they should after a lift. Rough Country recommends them with 3.5in to 6in suspension lift kits.
These rear coil spring correction plates fit the 2007-2017 Jeep Wrangler 4WD and RWD, covering Sport, Sport S, X, Sahara, Rubicon, 70th Anniversary and 75th Anniversary trims along with their Unlimited counterparts — check the fitment section for your exact submodel. Once a lift changes the rear axle position, the coil seats no longer sit square; these plates rotate the coil angle 10 degrees back toward correct and let the springs load evenly. Rough Country recommends them on 3.5in to 6in lift setups. The job bolts on, with an estimated 2-3 hours of install time and a downloadable installation guide available.
Specifications
Specs
| Brand | Rough Country |
| Part number | 1113 |
| UPC / GTIN | 00843030101091 |
| Shipping weight | 1 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Springs |
| Installation guide | Downloadable PDF |
Why buy here