WF1 Fender Flares for Jeep Gladiator (2020-2025)
- Fits 2020-2025 Jeep Gladiator 4WD, Sport through Rubicon X and Mojave
- 10-inch front and 6-inch rear flare width in UV-protected TPO
- Room for 35-inch tires on non-Rubicon, 37-inch on Rubicon, without a lift
- Factory inner fender liner must be removed; factory blinkers retained
- No-drill install with minor trimming; 2-3 hours listed
The Trail Fortress check
Will it fit your truck?
✓ Fits
Retains factory blinker. Factory inner fender liner must be removed. Fitment on this page is based on the manufacturer’s application data.
About this part
WF1 Fender Flares, fitment-checked
Gladiator-specific WF1 flares for 2020-2025 trucks, 10 inches wide up front and 6 inches at the rear. They open room for 35-inch tires on non-Rubicon Gladiators and 37-inch on a Rubicon with no lift kit. One install note that matters: the factory inner fender liner has to come out. The factory blinkers stay.
Every 2020-2025 Gladiator 4WD trim in the fitment table is covered — Sport, Sport S, Willys, Willys Sport, Overland, Mojave, Mojave X, Rubicon, Rubicon X, High Altitude, and the special editions. Clearance over the factory flare goes up 3/4 inch on Rubicon fronts and 2 inches on everything else, which is the difference between rubbing and not once the tires grow. Construction is UV-protected TPO with a light texture. Hardware is corrosion-resistant and included; expect minor trimming, removal of the factory inner fender liner, and roughly 2-3 hours.
Specifications
Specs
| Brand | Rough Country |
| Part number | A-J02022 |
| UPC / GTIN | 00840269912443 |
| Shipping weight | 28 lb |
| Warranty | Limited Lifetime Warranty |
| Country of origin | US |
| Category | Exterior Accessories › Fender Flares |
| Installation guide | Downloadable PDF |
Why buy here