Rear Fender & Quarter Panel Armor for 1984–1996 Jeep Cherokee
- Kit contains rear fender armor and rear quarter panel armor
- Fits 1984–1996 Jeep Cherokee XJ, 4WD and RWD
- Both panels are 3/16-inch plate steel
- Drilling required — downloadable installation guide and video available
The Trail Fortress check
Will it fit your truck?
✓ Fits
Requires drilling Fitment on this page is based on the manufacturer’s application data.
About this kit
Rear Fender & Quarter Panel Armor, fitment-checked
Rear-corner coverage for the 1984–1996 Jeep Cherokee XJ in one part number. 10578 pairs rear fender armor with the rear quarter panel armor (10573), both 3/16-inch plate steel — the two panels that take the worst of it on the back half of an XJ. Drilling is required.
Rear fender and quarter panel armor for the 1984–1996 Jeep Cherokee XJ, fitting 4WD and RWD models across the Base through Limited trim range. The set combines rear fender armor with rear quarter panel armor, so the wheel arch and the lower body beneath it are both covered in 3/16-inch plate steel rather than left to dent. Drilling is required. Rough Country publishes a downloadable installation guide plus a video walkthrough. Shipping weight: 48.38 lb.
What’s in the box
Kit contents
- 1× RR Fender Armor 10575
- 1× Quarter Panel Armor 10573
Rough Country shares subassemblies across kits, so individual package labels can carry broader application ranges. The complete 10578 kit fits the vehicles shown in the fitment section above.
Specifications
Specs
| Brand | Rough Country |
| Part number | 10578 |
| UPC / GTIN | 00843030150464 |
| Shipping weight | 48.38 lb |
| Country of origin | US |
| Category | Bumpers & Armor › Body Armor |
| Installation guide | Downloadable PDF |
Why buy here