Dual Steering Stabilizer for 1987–1995 Jeep Wrangler 4WD
- Fits 1987–1995 Jeep Wrangler 4WD, including Sahara, Laredo, Renegade, Islander, and Rio Grande submodels
- Requires 4 to 6.5 inches of suspension lift — will not work at stock ride height or above that range
- Factory steering setup only; not for Jeeps with aftermarket steering conversions
- Chrome-hardened 18mm piston rod; dual-damper layout reduces bump steer and tie rod wear
- Bolt-on install, estimated 1-2 hours — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
ONLY fits models equipped with 4 - 6.5-inch of suspension lift. ONLY fits models with stock steering setup. Fitment on this page is based on the manufacturer’s application data.
About this part
Dual Steering Stabilizer, fitment-checked
Rough Country 87307 is a dual steering stabilizer for the 1987–1995 Jeep Wrangler 4WD, built around a chrome-hardened 18mm piston rod. It fits only Wranglers already running 4 to 6.5 inches of suspension lift and retaining the factory steering setup. Bolt-on installation, estimated at 1-2 hours.
This dual steering stabilizer for the 1987–1995 Jeep Wrangler 4WD covers Base, S, SE, Sport, Laredo, Sahara, Renegade, Islander, and Rio Grande submodels — but only those with 4 to 6.5 inches of suspension lift and unmodified factory steering components. Doubling up the dampers settles wheel feedback over washboard and rock, trims bump steer, and takes load off the tie rod ends and ball joints. The 18mm piston rod is chrome hardened. Mounting is bolt-on with an estimated 1-2 hours of shop time, and a downloadable Rough Country installation guide is available before you start.
Specifications
Specs
| Brand | Rough Country |
| Part number | 87307 |
| UPC / GTIN | 00843030115531 |
| Shipping weight | 10 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Steering Stabilizers |
| Installation guide | Downloadable PDF |
Why buy here