Lower Control Arm Skid Plate Kit for Jeep Wrangler 4WD (2018-2026)
- Fits 2018-2026 Jeep Wrangler 4WD, including Rubicon, Sahara, Willys, 392, and 4xe submodels listed in the fitment table
- Cut from 3/16-inch plate steel to guard the lower control arms against trail impacts
- Works with stock and short arm suspension, plus Rough Country long arm suspensions
- Listed install time: 30 minutes — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
About this part
Lower Control Arm Skid Plate Kit, fitment-checked
Rough Country 10589 is a lower control arm skid plate kit for 2018-2026 Jeep Wrangler 4WD models, cut from 3/16-inch plate steel to shield the lower arms from rocks and trail debris. It works with stock and short arm suspension setups, and with Rough Country long arm suspensions. Rough Country lists the install at 30 minutes.
This lower control arm skid plate kit fits 2018-2026 Jeep Wrangler 4WD models across the two- and four-door lineup, from Sport and Willys through Sahara, High Altitude, Rubicon, and the 392 and 4xe variants listed in the fitment section. The 3/16-inch plate steel armor takes the hits your lower arms would otherwise absorb on rock and rutted two-track. Fitment is not limited to factory geometry: stock and short arm suspensions bolt up, as do Rough Country long arm setups. Rough Country lists a 30 minute install, and a downloadable installation guide is available before you start.
Specifications
Specs
| Brand | Rough Country |
| Part number | 10589 |
| UPC / GTIN | 00843030154844 |
| Shipping weight | 5 lb |
| Country of origin | US |
| Category | Bumpers & Armor › Skid Plates & Underbody |
| Installation guide | Downloadable PDF |
Why buy here