MLC-6 Multiple Light Controller for Jeep Wrangler 4WD (2018-2026)
- Fits 2018-2026 Jeep Wrangler 4WD and the 2018 Wrangler JK — see the full submodel list below
- Does not fit diesel models
- Six switched circuits: 40-amp plug-in cube relays, 30-amp ATO fuses, and diodes against LED field collapse
- 12-position accessory terminal block; 8-gauge battery leads with crimped and soldered terminals, inline 50-amp resettable breaker
- Integrated low-voltage cut-off circuit and an on/off button for switch backlighting
- Jeep Wrangler mounting brackets and hardware included; downloadable installation guide available. Shipping weight: 7.9 lb
The Trail Fortress check
Will it fit your truck?
✓ Fits
✕ Does not fit
- Diesel models
About this part
MLC-6 Multiple Light Controller, fitment-checked
Rough Country 70964 is the MLC-6 multiple light controller for 2018-2026 Jeep Wrangler 4WD models, plus the 2018 Wrangler JK. It runs six switched accessory circuits through plug-in 40-amp cube relays with 30-amp ATO fuses, and ships with the brackets and hardware needed for Jeep Wrangler mounting. It does not fit diesel models.
The MLC-6 multiple light controller for the 2018-2026 Jeep Wrangler 4WD gives six switched circuits for lights and other accessories, wired through a 12-position terminal block. Each circuit uses a plug-in 40-amp cube relay, a 30-amp ATO fuse, and a diode to guard against LED field collapse, while an inline 50-amp manual-reset breaker protects the 8-gauge battery leads. An integrated low-voltage cut-off circuit watches battery state, and a button shuts off switch backlighting. Diesel Wranglers are not covered. A downloadable Rough Country installation guide is available before you start wiring.
Specifications
Specs
| Brand | Rough Country |
| Part number | 70964 |
| UPC / GTIN | 00843030159337 |
| Shipping weight | 7.9 lb |
| Country of origin | CN |
| Category | Lighting › Wiring & Switches |
| Installation guide | Downloadable PDF |
Why buy here