
Control Arm Relocation Kit for Jeep Wrangler (2018-2025)
- Drops the factory control arm mounts by 3 inches to correct arm angle after a lift
- Fits the 2018-2025 Jeep Wrangler 4WD and 2020-2025 Gladiator 4WD
- Improves drive-shaft angle and ride quality without replacing the arms
- Fits models with 3.5 of suspension running stock control arms
- Bolt-on installation with a downloadable guide
Will it fit your truck?
✓ Fits
Fits models with 3.5 of suspension with stock control arms. Fitment on this page is based on the manufacturer’s application data.
More for your truck
Control Arm Relocation Kit, fitment-checked
Relocation brackets that drop the factory control arm mounts by 3 inches on the Jeep Wrangler 4WD, 2018-2025, and Gladiator 4WD, 2020-2025. Lowering the mounting point flattens the arm angle a lift steepened, which settles the ride and eases the strain on the drive-shaft. Fits models with 3.5 of suspension running stock control arms.
Lift a Jeep and the control arms end up pointing downhill from the frame, which shortens the wheelbase slightly and puts the drive-shaft at an angle it does not enjoy. Rather than replacing the arms, these brackets move the frame-side mounts down 3 inches so the stock arms sit closer to level again. Ride quality comes back, drive-shaft angle improves, and the arms you already own stay on the truck. Bolt-on, with a downloadable guide.
Rough Country 110602 Installation Instructions
Specifications
| Brand | Rough Country |
| Part number | 110602 |
| UPC / GTIN | 00843030175078 |
| Shipping weight | 14.42 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Control Arms & Track Bars |
Why buy here
More Control Arms & Track Bars

















