Control Arm Relocation Brackets for Jeep Wrangler JK
- Fits 2007-2017 Jeep Wrangler in 4WD and RWD — check the fitment table for your submodel
- For builds with 3.5 to 4in of suspension on factory control arms
- At 6in of lift, an adjustable short-arm design is required instead
- Corrects front control-arm and driveshaft angles after a lift
- Bolt-on install, 2-3 hours; downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
Fits models with 3.5 - 4in of suspension with stock control arms. Fits models with 6in of suspension with adjustable short arm design. Fitment on this page is based on the manufacturer’s application data.
About this part
Control Arm Relocation Brackets, fitment-checked
A relocation bracket kit for 2007-2017 Jeep Wrangler models carrying 3.5 to 4in of suspension on factory control arms. Jeeps sitting at 6in need an adjustable short-arm design instead. Lowering the arm mounting points brings control-arm and driveshaft angles back toward where the chassis expects them. Shipping weight: 19 lb.
The brackets fit 2007-2017 Jeep Wrangler and Wrangler Unlimited trims listed in the fitment section, in both 4WD and RWD form. They apply to builds running 3.5 to 4in of suspension on stock control arms; at 6in, the arrangement calls for an adjustable short-arm design instead. Dropping the mounting points pulls front control-arm and driveshaft angles back into a workable range, which is what settles the ride down after a lift. Everything bolts on, install runs 2-3 hours, and a downloadable Rough Country installation guide is available.
Specifications
Specs
| Brand | Rough Country |
| Part number | 110600 |
| UPC / GTIN | 00843030145224 |
| Shipping weight | 19 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Control Arms & Track Bars |
| Installation guide | Downloadable PDF |
Why buy here