Track Bar Bracket & Drop Pitman Arm for Jeep TJ (1997-2006)
- Fits 1997-2006 Jeep Wrangler TJ 4WD with a 4in or 6in suspension lift
- Track bar stays in the factory axle mount: no new axle hole to drill
- 4in lifts use the stock front track bar; 6in lifts require a factory-style adjustable bar
- Drop pitman arm restores steering angle and eases load on tie rod ends
- Bolt-on, listed at 1-2 hours; downloadable installation guide available
Will it fit your truck?
✓ Fits
Fits 4in lifted TJ models equipped with the stock front track bar. Fits 6in lifted TJ models equipped with a factory style adjustable front track bar. Fitment on this page is based on the manufacturer’s application data.
More for your truck
Track Bar Bracket & Drop Pitman Arm, fitment-checked
For 1997-2006 Jeep Wrangler TJ models, this bracket and drop pitman arm pair keeps the front track bar in its factory axle mount after a 4in or 6in lift, so there is no fresh hole to drill in the axle. The 4in application uses the stock front track bar; the 6in application calls for a factory-style adjustable front bar.
Lifting a TJ pulls the front axle off center and steepens the steering angle. This bolt-on pair addresses both at once: the bracket lets the track bar stay in its original axle mount, which saves drilling the axle housing, and the drop pitman arm brings steering geometry back toward stock so tie rod ends see less strain over their life. Match the application to your setup. 4in lifts run the stock front track bar, while 6in lifts need a factory-style adjustable one. Rough Country lists the job at 1-2 hours and a downloadable installation guide is available.
Specifications
| Brand | Rough Country |
| Part number | 1063 |
| UPC / GTIN | 00843030100698 |
| Shipping weight | 11 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Control Arms & Track Bars |
Why buy here
More Control Arms & Track Bars
