3.5-Inch Lift Kit with M1 Shocks for Jeep Wrangler JK 2-Door
- Fits 2007-2017 Jeep Wrangler JK 4WD two-door trims listed in the fitment table — does not fit four-door models
- Ships as a kit: two lift boxes plus two M1 Monotube shock pairs
- Control arm drop brackets and rear coil correction plates (10-degree coil angle change) address suspension geometry
- 2012-2018 applications need exhaust modification for front driveshaft clearance; a smaller-diameter shaft (SKU 1030) addresses automatic-transmission pan
- Bolt-on install with no cutting — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
✕ Does not fit
- 4-door models
2012-2018 models require exhaust modifications to clear the front driveshaft SKU: 1030. On Automatic equipped vehicles due to use of an oversize driveshaft from the factory and inadequate factory clearance it may be possible for the front driveshaft to come in contact with the automatic transmission pan tearing the factory boot and rubbing on the shaft. Generally this occurs during heavy articulation when front sway bar links are disconnected and longer shocks are installed. If this is found to occur the proper procedure would be to replace the oversize factory shaft with an aftermarket smaller diameter shaft to increase clearance between the transmission and front driveshaft. Rough Country does offer this driveshaft if needed. Fitment on this page is based on the manufacturer’s application data.
About this kit
3.5-Inch Lift Kit with M1 Shocks, fitment-checked
Rough Country 69340 is a 3.5-inch lift kit for the 2007-2017 Jeep Wrangler JK in 4WD two-door form, packaged with two M1 Monotube shock pairs. It does not fit four-door models. Bolt-on installation with no cutting, and the kit uses control arm drop brackets plus rear coil correction plates to reset suspension angles.
This 3.5-inch lift kit for the 2007-2017 Jeep Wrangler JK 4WD covers two-door Sport, Sport S, X, Sahara, Rubicon, and the 70th and 75th Anniversary trims listed in the fitment section; four-door models are excluded. Control arm drop brackets bring alignment geometry back into range, rear correction plates shift coil spring angle by 10 degrees, and the coil springs are matched to factory spring rate. On 2012-2018 applications, exhaust modification is needed for front driveshaft clearance, and automatic-equipped vehicles may see driveshaft-to-transmission-pan contact under heavy articulation. A downloadable installation guide is available.
What’s in the box
Kit contents
- 1× 3.5in 2dr Kit Box 1608BOX1
- 1× 3.5in Vertex Kit Box 1693BOX2
- 1× M1 MONOTUBE SHOCK PAIR 770740P
- 1× M1 MONOTUBE SHOCK PAIR 770750P
Rough Country shares subassemblies across kits, so individual package labels can carry broader application ranges. The complete 69340 kit fits the vehicles shown in the fitment section above.
Specifications
Specs
| Brand | Rough Country |
| Part number | 69340 |
| UPC / GTIN | 00840269918643 |
| Lift height | 3.5 in |
| Shock package | M1 series |
| Shipping weight | 121 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Lift Kits |
Why buy here
The fitment-first store
Keep looking
More Lift Kits
6 Inch
4 Inch
6 Inch
4 Inch
4 Inch
6 Inch
4 Inch
6 Inch
4 Inch
4 Inch
4 Inch
3.5 Inch
3.5 Inch
3.5 Inch
3.5 Inch
4 Inch