3.5-Inch Lift Kit with M1R Shocks for 2007–2017 Jeep Wrangler JK 4WD
- Fits 2007–2017 Jeep Wrangler JK 4WD two-door only — does not fit 4-door models
- Kit contents: 3.5in 2dr kit box, 3.5in Vertex kit box, and two M1R monotube reservoir shock pairs
- Rear coil correction plates reset coil spring angle by 10 degrees; control arm drop brackets restore alignment geometry
- 2012-2018 vehicles require exhaust modification to clear the front driveshaft (SKU 1030)
- Bolt-on install with no cutting — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
✕ Does not fit
- 4-door models
2012-2018 models require exhaust modifications to clear the front driveshaft SKU: 1030. On Automatic equipped vehicles due to use of an oversize driveshaft from the factory and inadequate factory clearance it may be possible for the front driveshaft to come in contact with the automatic transmission pan tearing the factory boot and rubbing on the shaft. Generally this occurs during heavy articulation when front sway bar links are disconnected and longer shocks are installed. If this is found to occur the proper procedure would be to replace the oversize factory shaft with an aftermarket smaller diameter shaft to increase clearance between the transmission and front driveshaft. Rough Country does offer this driveshaft if needed. Fitment on this page is based on the manufacturer’s application data.
About this kit
3.5-Inch Lift Kit with M1R Shocks, fitment-checked
Rough Country 69344 is a 3.5-inch lift kit for 2007–2017 Jeep Wrangler JK 4WD two-door models, built around Vertex-boxed kit hardware and two pairs of M1R monotube reservoir shocks. It bolts on without cutting. It does not fit 4-door models, and 2012-2018 vehicles need exhaust modification for front driveshaft clearance.
This 3.5-inch lift kit for the 2007–2017 Jeep Wrangler JK 4WD covers X, Sport, Sport S, Sahara, Rubicon, and the 70th and 75th Anniversary submodels listed in the fitment section. The boxed hardware pairs control arm drop brackets with rear coil correction plates that reset the coil angle by 10 degrees, and coil springs matched to the factory rate. Two M1R monotube reservoir shock pairs handle damping. Automatic-equipped Jeeps can see front driveshaft-to-transmission-pan contact under heavy articulation with the sway bar links disconnected; a smaller-diameter shaft resolves it. A downloadable installation guide is available.
What’s in the box
Kit contents
- 1× 3.5in 2dr Kit Box 1608BOX1
- 1× 3.5in Vertex Kit Box 1693BOX2
- 1× M1R MONOTUBE RESI SHOCK PAIR 770740RESP
- 1× M1R MONOTUBE RESI SHOCK PAIR 770750RESP
Rough Country shares subassemblies across kits, so individual package labels can carry broader application ranges. The complete 69344 kit fits the vehicles shown in the fitment section above.
Specifications
Specs
| Brand | Rough Country |
| Part number | 69344 |
| UPC / GTIN | 00840269975141 |
| Lift height | 3.5 in |
| Shipping weight | 121 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Lift Kits |
Why buy here
The fitment-first store
Keep looking
More Lift Kits
6 Inch
4 Inch
6 Inch
4 Inch
4 Inch
6 Inch
4 Inch
6 Inch
4 Inch
4 Inch
4 Inch
3.5 Inch
3.5 Inch
3.5 Inch
3.5 Inch
4 Inch