3.5-Inch Lift Kit with M1R Shocks for Wrangler Unlimited (2007-2017)
- Fits 2007-2017 Jeep Wrangler Unlimited four-door models in 4WD and RWD — see the full submodel list
- Does not fit 2-door models; 2012-2018 vehicles require exhaust modification for front driveshaft clearance
- Kit contents: Vertex kit box, Unlimited kit box, and two M1R monotube reservoir shock pairs
- Control arm drop brackets plus rear coil correction plates that shift coil angle 10 degrees
- Bolt-on install with no cutting — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
✕ Does not fit
- 2-door models
2012-2018 models require exhaust modifications to clear the front driveshaft SKU: 1030. On Automatic equipped vehicles due to use of an oversize driveshaft from the factory and inadequate factory clearance it may be possible for the front driveshaft to come in contact with the automatic transmission pan tearing the factory boot and rubbing on the shaft. Generally this occurs during heavy articulation when front sway bar links are disconnected and longer shocks are installed. If this is found to occur the proper procedure would be to replace the oversize factory shaft with an aftermarket smaller diameter shaft to increase clearance between the transmission and front driveshaft. Rough Country does offer this driveshaft if needed. Fitment on this page is based on the manufacturer’s application data.
About this kit
3.5-Inch Lift Kit with M1R Shocks, fitment-checked
Rough Country 69444 is a 3.5-inch lift kit for 2007-2017 Jeep Wrangler Unlimited four-door models, built around a Vertex kit box and two pairs of M1R monotube reservoir shocks. It does not fit 2-door models. Bolt-on installation with no cutting called for in the feed notes.
This 3.5-inch lift kit for the 2007-2017 Jeep Wrangler Unlimited ships as a Vertex kit box plus an Unlimited kit box and two M1R monotube reservoir shock pairs, covering Sport, Sport S, X, Sahara, Rubicon, and the 70th and 75th Anniversary submodels in 4WD and RWD. Control arm drop brackets bring alignment geometry back in line, and rear coil correction plates reset the coil angle by 10 degrees. Two-door models are excluded, and 2012-2018 Jeeps need exhaust modification for front driveshaft clearance. A downloadable installation guide is available.
What’s in the box
Kit contents
- 1× Unltd Kit Box 1609BOX4
- 1× 3.5in Vertex Kit Box 1693BOX2
- 1× M1R MONOTUBE RESI SHOCK PAIR 770740RESP
- 1× M1R MONOTUBE RESI SHOCK PAIR 770750RESP
Rough Country shares subassemblies across kits, so individual package labels can carry broader application ranges. The complete 69444 kit fits the vehicles shown in the fitment section above.
Specifications
Specs
| Brand | Rough Country |
| Part number | 69444 |
| UPC / GTIN | 00840269975110 |
| Lift height | 3.5 in |
| Shipping weight | 120.8 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Lift Kits |
| Installation guide | Downloadable PDF |
Why buy here