3.5-Inch Lift Kit with V2 Shocks for Jeep Wrangler Unlimited
- Fits 2007-2017 Jeep Wrangler Unlimited (Sport, Sport S, X, Sahara, Rubicon, and Anniversary editions) — see the full fitment list
- Does not fit 2-door models; 2012-2018 applications require exhaust modification for front driveshaft clearance
- Kit contents: Vertex 3.5in kit box, Unlimited kit box, and two V2 monotube shock pairs
- Control arm drop brackets plus rear coil correction plates that shift coil angle 10 degrees
- Bolt-on install, no cutting — downloadable installation guide available
The Trail Fortress check
Will it fit your truck?
✓ Fits
✕ Does not fit
- 2-door models
2012-2018 models require exhaust modifications to clear the front driveshaft SKU: 1030. On Automatic equipped vehicles due to use of an oversize driveshaft from the factory and inadequate factory clearance it may be possible for the front driveshaft to come in contact with the automatic transmission pan tearing the factory boot and rubbing on the shaft. Generally this occurs during heavy articulation when front sway bar links are disconnected and longer shocks are installed. If this is found to occur the proper procedure would be to replace the oversize factory shaft with an aftermarket smaller diameter shaft to increase clearance between the transmission and front driveshaft. Rough Country does offer this driveshaft if needed. Fitment on this page is based on the manufacturer’s application data.
About this kit
3.5-Inch Lift Kit with V2 Shocks, fitment-checked
Rough Country 69470 is a 3.5-inch lift kit for 2007-2017 Jeep Wrangler Unlimited models, built around a Vertex kit box and two pairs of V2 monotube shocks. It does not fit 2-door models. On 2012-2018 applications, exhaust modification is needed for front driveshaft clearance.
This 3.5-inch lift kit for the 2007-2017 Jeep Wrangler Unlimited ships as a bolt-on package with no cutting called for: control arm drop brackets to bring front geometry back in line, rear coil correction plates that reset the coil angle by 10 degrees, coil springs matched to the factory rate, and two V2 monotube shock pairs. Automatic-equipped Jeeps with the oversize factory front driveshaft can see contact with the transmission pan under heavy articulation; a smaller-diameter aftermarket shaft resolves it. Read the exclusions, then work through the downloadable Rough Country installation guide before you start.
What’s in the box
Kit contents
- 1× Unltd Kit Box 1609BOX4
- 1× 3.5in Vertex Kit Box 1693BOX2
- 1× V2 MONOTUBE SHOCK PAIR 760740-2
- 1× V2 MONOTUBE SHOCK PAIR 760750-2
Rough Country shares subassemblies across kits, so individual package labels can carry broader application ranges. The complete 69470 kit fits the vehicles shown in the fitment section above.
Specifications
Specs
| Brand | Rough Country |
| Part number | 69470 |
| UPC / GTIN | 00843030161439 |
| Lift height | 3.5 in |
| Shipping weight | 120.3 lb |
| Country of origin | US |
| Category | Suspension & Lift Kits › Lift Kits |
Why buy here
The fitment-first store
Keep looking
More Lift Kits
6 Inch
4 Inch
6 Inch
4 Inch
4 Inch
6 Inch
4 Inch
6 Inch
4 Inch
4 Inch
4 Inch
3.5 Inch
3.5 Inch
3.5 Inch
3.5 Inch
4 Inch